-
Cellar Size: 1000 cu. ft. (Properly Insulated Cellar)
-
BTUh: 3650 with 90°F air entering the condenser coil
-
dBA: Evaporator: 54 Decibels, Condenser: 65 Decibels
-
Dimensions: Evaporator: 20.5'W x 15.5'H x 16'D Condenser: 11.5'W x 9.91'H x 16'D
-
Weight: Evaporator: 56lbs Condenser: 56lbs
-
AMPS (starting/running): Evaporator: 2/1 Condenser: 15/10
-
Installation: Evaporator is installed in the cellar, Condenser is installed up to 100 line ft. away.
-
Temp. Delta: 55°F temperature differential
-
Thermostat: Digital Control Display
BTUh Rating:
There are circumstances in which a cellar design may require a larger unit due to some existing design restrictions.
There are several factors such as glass, stone, concrete, etc. which will seem adequate but do not offer the insulation capacity required to maintain the optimum environment.
We recommend purchasing a unit with a larger capacity to compensate for the design limitations.
Note: The systems do not include a line set.
New Cold Weather Start Kit:
WhisperKOOL is proud to present our cold weather start kit. INCLUDED FREE FOR THIS UNIT, This kit was designed exclusively for our split systems where the condensing unit will be installed in extremely cold environments. Our split systems are designed to be adaptable to almost any install, as the condensing unit can be located in a variety of locations such as a mechanical room, basement, back yard, or even a rooftop. Our split systems were designed to operate with the condensing unit exposed to temperatures between 20°F and 110°F. However, there are some areas in the country that may drop below 20°F. Due to these conditions WhisperKOOL designed the Cold Weather Start Kit.
So, when the outside temperatures drop, the pressure in the system drops as well. This presents a challenge because our systems operate using a pump down cycle and a low-pressure switch to turn the compressor on and off. However when the temperature drops below 20°F, the pressure in the system is too low to start the compressor. The use of an electronic bypass is needed to start the compressor and temperature controlled heaters installed on the receiver are needed to raise the pressure in the system to optimal levels.
The Cold Weather Start Kit will bypass the low-pressure switch on startup and keep the pressure in the system high enough to operate correctly for environments as cold as -15°F.
It is important that the cooling system stays operational during cold weather conditions, as heating the house using the central HVAC system will indirectly increase the temperature of the wine cellar. This kit will ensure that the cooling system will continue to operate efficiently in cold weather environments to maintain an optimal wine storage temperature.
Cold Weather Start Kit Video
New 24V Thermostat Conversion Kit:
- Connect your thermostat to Wi‑Fi to control the temperature from your phone, tablet, or laptop.
- Monitor temperature and humidity through smartphones.
- Monitor run time and energy usage.
- Set alarm notifications
- View your cellar conditions from your cellular device.
The use of the 24-volt thermostat conversion kit eliminates the thermostat normally included with the system and allows your contractor to select, purchase and install the thermostat technology of your choice, including but not limited to:
Note:
- By selecting the 24V Thermostat Conversion Kit, you have acknowledged that the system will not be built with the standard WhisperKOOL control or liquid measuring bottle probe. You will have to source and purchase your own 24V thermostat to run the equipment.
